[Scilab-users] XCos

[Clément David]

Hello,

> 1. Debug output: I have a type 4 computational function writen in c. I try to print some debug output to the scilab console. printf fails, it prints to stdout, that is my xterm. I tried to use Coserror but without any result in the scilab or xterm terminal. scicos.h and scicos_block4.h do not provide any other possibility, so what possibility do i have?
Did you try sciprint from sciprint.h - output_stream.dll ?

> 2. Grafical Update: If I change a block parameter which create a new block output, the output is shown, but the output label for the new port is not shown. But  if i reopen the parameter dialog and set the parameter again the Label is shown.
I guess this is a bug, can you report it to bugzilla.scilab.org with a reduced test_case please ?

> 3. Input/output datatype: If I create new block outputs I create them via set_io, everything is ok, the block detail dialog shows the correct settings. But if I try to connect the port does not have the correct datatypes. I appended the detail dialog and the model.
> If you look at the configuration, port 1,2 have correct datatype (uint8), 3 +4 should be real, but if I connect a block it shows me that it has a invalid datatype 8 => uint8. Is there an model update missing?
Maybe also a bug, are you able to reproduce with GAINBLK (from the
standard palette) ?

-- 
Clément DAVID
Development Engineer
-----------------------------------------------------------
Scilab Enterprises
143bis rue Yves Le Coz - 78000 Versailles, France
Mobile: +33.6.26.26.51.90
Phone: +33.2.90.22.78.96
http://www.scilab-enterprises.com