[Scilab-users] Advice needed on file parsing
Richard llom
richard.llom at gmail.com
Sun Jun 18 23:10:01 CEST 2017
Hello fellow scilab-users,
I'm writing a script to read and process files, which are constructed as
follows:
<file start>
PCB: 007
ASM: 000
LOT: 00000
FW: 1477971088
CH1: AMPS 10A
CH2: VOLT 60V
SMPL: 0064 0125Hz
DESC: 12V CU LOG
UTC TIME SEC ,CH1 AMPS DC ,CH2 VOLT DC
1497812372.910, 8.609146E-03, 1.210613E001
1497812373.895, 1.577809E-01, 1.207540E001
1497812374.578, 1.010268E000, 1.193087E001
... [snip]
<file end>
To process this file further, I need:
1)
the first eight lines stored in pairs, e.g.
info(1,1) should yield "PCB" and info(1,2) should yield "007" (string is ok)
2)
line #9 (header), should be available as header(1)="UTC TIME SEC", etc...
3)
line 10+
these should be scanned in as a matrix.
I already tried csvread and msscanf (?), however with no luck so far...
So if someone could just point me to the apropiates function for each task.
I hopefully can take it then from there.
Thanks & cheers
richard
--
View this message in context: http://mailinglists.scilab.org/Advice-needed-on-file-parsing-tp4036587.html
Sent from the Scilab users - Mailing Lists Archives mailing list archive at Nabble.com.
More information about the users
mailing list