[Scilab-users] Xcos - simulation problem with Backlash block
Tomasz Garstka
tomasz.garstka at wip.pcz.pl
Mon Mar 20 20:58:39 CET 2017
Hello
I'm simulating in Xcos simple closed control loop (servo) with inertia
block (1/1+Ts) as ramp function of drive. That's run OK. When I added
Backlash block (to simulate real screw gear), the simulation take a long,
long time without effect.
If I remove inertia block, run OK, but no with both blocks.
How I can solve this problem?
Thank You
Tomasz
More information about the users
mailing list