[Scilab-users] figure_size

[Samuel Gougeon]

Le 10/09/2017 à 17:37, Claus Futtrup a écrit :
> Hi Samuel
>
> Thanks for all the (different email) responses - and below tip how to 
> directly put the figure size with the scf() command. This directly 
> answers my initial question. Thanks.
>
> How do you guys figure this out? Looking directly in the Scilab 
> source-code? :-)

That's right, Claus, this new feature named "Recursive extraction" is 
not documented (*), and even not announced in the 6.0.0 CHANGES page! 
Apparently, it must remain confidential. It was just announced at the 
last 2015 Scilabtech, and already sometimes addressed in this ML.
(*) http://bugzilla.scilab.org/14211#c6

Best regards
Samuel