[Scilab-users] Changing polyline properties in param3d1

[Izabela Wójcik-Grząba]

Thank you. It's quite a good idea. Shorter than mine, for sure.

Iza




W dniu 19.07.2018 12:49, Rafael Guerra napisał(a):
> Then the following 'if' clause might be preferable, especially if you
> have many properties to change:
> 
> if size(X,2)==1 then
>     X = [X X];
>     Y = [Y Y];
>     Z = [Z Z];
> end
> param3d1(X,Y,Z);
> gce().children.polyline_style=4;
> gce().children.thickness=2;
> gce().children.foreground=32;
> etc...
> 
> Regards,
> Rafael
> 
> -----Original Message-----
> From: users <users-bounces at lists.scilab.org> On Behalf Of Izabela 
> Wójcik-Grzaba
> Sent: Thursday, July 19, 2018 12:00 PM
> To: Users mailing list for Scilab <users at lists.scilab.org>
> Subject: Re: [Scilab-users] Changing polyline properties in param3d1
> 
> Thank you for your answer, but here all the polylines have the same
> properties. The problem is when there is only one polyline because the
> levels structure of figure properties are different then in the case
> of multiple polylines.
> But, as there is no other idea, I will stick with my "if" clause :-)
> 
> Iza
> 
> _______________________________________________
> users mailing list
> users at lists.scilab.org
> http://lists.scilab.org/mailman/listinfo/users