Debugging a Scilab crash

[Mike Page]

Hi,

I have some error in my Scilab code that occasionally crashes Scilab.  I am
fairly sure it is my fault, because the crash has only started happening
recently after I made some major changes.  When the crash occurs, Scilab
just exits with no error message.  The only log file produced by the crash
is the one attached (unless there are others I have not seen).

Can anyone give a clue where I should start to look for this problem?  Does
the log file give a clue as to what went wrong?  Is there any debug mode to
run Scilab that might provide extra information?

Without a clue, it is quite hard to debug this problem, because my Scilab
code is several thousand lines long and runs with attached real-time
hardware.  If I pause the execution, the hardware overruns and the code does
not proceed normally.  Additionally, this crash only happens about one time
in twenty or so.

Any help would be much appreciated.

Regards,
Mike.
-------------- next part --------------
A non-text attachment was scrubbed...
Name: hs_err_pid2976.log
Type: application/octet-stream
Size: 18413 bytes
Desc: not available
URL: <https://lists.scilab.org/pipermail/users/attachments/20110726/f1c9d399/attachment.obj>