[Scilab-users] ?=Re: ?=Re: ?=Re: ?==?utf-8?q?

[Stéphane Mottelet]

Hello,

Le 24/09/2019 à 02:48, fujimoto2005 a écrit :
> Dear all,
>
> Thanks for a lot of information.
>
> If the documentation contained information on the workable version, it would
> be much better for users.

Feel free to help making the documentation better. Scilab is free 
software and cannot be improved if active users do not start  to help.

> Now the almost documentations have a warning message "Please note that the
> recommended version of Scilab is 6.0.2. This page might be outdated. See the
> recommended documentation of this function".
>
> Such warning message is very helpful for the special function workable for
> only the old version.
>
> By the way is there any parallel computing tool for version 6.0.2?
no
> I am solving the stochastic control problem.
> The problem has about 20,000 lattice nodes with 2 dimensions for each time
> step, and time steps are 15.
> Though calculation on one node is independent each other in each time step,
> it uses "optim" and "intg" so that the vectorization of the node is
> impossible.
> I use loop 300 thousand times.
> Any tools of paralell conputing are welcome.

The only possible/workable setup is : Scilab 5.5.2 + Linux

S.

>
> Best regards,
>
> Masahiro Fujimoto
>
>
>
> --
> Sent from: https://antispam.utc.fr/proxy/1/c3RlcGhhbmUubW90dGVsZXRAdXRjLmZy/mailinglists.scilab.org/Scilab-users-Mailing-Lists-Archives-f2602246.html
> _______________________________________________
> users mailing list
> users at lists.scilab.org
> https://antispam.utc.fr/proxy/1/c3RlcGhhbmUubW90dGVsZXRAdXRjLmZy/lists.scilab.org/mailman/listinfo/users

-- 
Stéphane Mottelet
Ingénieur de recherche
EA 4297 Transformations Intégrées de la Matière Renouvelable
Département Génie des Procédés Industriels
Sorbonne Universités - Université de Technologie de Compiègne
CS 60319, 60203 Compiègne cedex
Tel : +33(0)344234688
http://www.utc.fr/~mottelet